HMGforum.com

Posted: **Mon Nov 01, 2010 2:48 am**

Hello everyone:
This is the first I work with print system. Attachment is my coding block. I put MsgInfo() where I would to check if program go through or not. The answer is yes. But nothing display on the screen at al even if I set PREVIEW. Where did I go wrong?
Please Help!
Best Regrads.
chen min

Posted: **Mon Nov 01, 2010 4:57 am**

Hi,

You have to select the printer first!

Code: Select all

select printer default preview

or

select printer cPrinterName preview

or

select printer dialog

Kindly see /hmg/samples/print folder.

Posted: **Mon Nov 01, 2010 8:25 am**

rathinagiri wrote:Hi,
You have to select the printer first!
........
Kindly see /hmg/samples/print folder.

Sorry guy!
It's all my fault!
It's all because an unbalance START PRINTDOC.
Best Regards
chen min

HMGforum.com

Nothing displayed on sceen even PREVIEW was setup!

Nothing displayed on sceen even PREVIEW was setup!

Re: Nothing displayed on sceen even PREVIEW was setup!

Re: Nothing displayed on sceen even PREVIEW was setup!